MiniCure3D Adhesive and Coating Curing

Ready for product insertion

With product inserted

During cure cycle

The MiniCure3D is perfect for attaching catheter balloon tips, hubs, etc.

MiniCure3D Advantages:

• Full 360° uniform adhesive or coating cure in as little as 5 seconds
• Uniform, 360° high-performance adhesion
• Product is bathed in uniform UV light — no rotation or motion required
• Product stays cool — uniformity means no over-curing
• Uses single pole light guide; no multiple pole guides to balance, wear out and replace
• Use either arc lamp or LED spot cure UV source
• Compatible with all popular spot cure UV sources and light guides, including fiber and liquid filled
• Repeatable, reliable and stable — fewer operator error opportunities
• Secure bushings facilitate product positioning
  • Holds assembly for dispensing and curing
  • Sized for variety of catheters; custom sizes available
• Easy to clean — just wipe with water or alcohol
• Inherently safe — no open-framed jigs needed

Manual or Automatic Operation

Vela MiniCure3D Plus LCD touch screen controller Pre-set UV exposure for your part Set optimal UV dose (J/cm2) Or set UV exposure time (W/cm2) Sensor measures actual UV dose delivered to part, not light exiting light guide Dependable, repeatable UV dose control for every UV treated part Low UV alarm warns of lamp problem, prevents improper exposure Start/stop operation with foot switch or touch screen Chamber safety interlock prevents UV light operation when lid is open

Vela MiniCure 3D Manual Start/stop operation using UV light source or foot pedal Lamp timer controls exposure time Chamber safety interlock prevents UV light operation when lid is open